EN AW-6060 vs EN AW-1050A: 34% composition overlap. Significantly different materials serving different application areas.
EN AW-6060 vs EN AW-1050A
Side-by-side chemical composition and mechanical property comparison.
Overview
EN AW-6060
3.3206
The most widely extruded aluminum alloy in Europe. Lower strength than 6063 but excellent extrudability and surface quality. Used for architectural profiles (window frames, curtain walls, door frames), furniture, heat sinks, and general-purpose extrusions. T6 temper for structural use; T5 for decorative.
EN AW-1050A
3.0255
Commercially pure aluminum (99.5% Al minimum). Excellent corrosion resistance, highest thermal and electrical conductivity among Al alloys, and outstanding formability. Low strength (UTS ~100 MPa annealed) limits structural use. Non-heat-treatable — strengthened only by cold work (H14/H24 tempers). Used for chemical processing equipment, food packaging foil, reflectors, heat exchangers, electrical busbars, capacitor foils, and architectural cladding/roofing. The baseline aluminum for conductivity applications.
| EN AW-6060 | EN AW-1050A | |
|---|---|---|
| Material Number | 3.3206 | 3.0255 |
| Category | Aluminum | Aluminum |
| Standard | EN 573-3 | EN 573-3 |
Chemical composition (wt%)
| Element | EN AW-6060 | EN AW-1050A | Overlap |
|---|---|---|---|
| Si | 0.3–0.6% | ≤ 0.25% | No overlap |
| Mn | 0–0.1% | ≤ 0.05% | OK |
| Cr | 0–0.05% | — | — |
| Cu | 0–0.1% | ≤ 0.05% | OK |
Mechanical properties
| Property | EN AW-6060 | EN AW-1050A | Unit |
|---|---|---|---|
| tensile_strength | ≥ 190 | 65–95 | MPa |
| yield_strength | ≥ 150 | ≥ 20 | MPa |
| elongation | ≥ 8 | ≥ 25 | % |
Compatibility Assessment
EN AW-6060 and EN AW-1050A have significantly different compositions (34% overlap). These materials are not interchangeable and serve different application areas.
Automated assessment based on composition analysis
Frequently Asked Questions
Is EN AW-6060 the same as EN AW-1050A?
EN AW-6060 and EN AW-1050A have a 34% composition overlap. They are generally not directly interchangeable.
Can I replace EN AW-6060 with EN AW-1050A?
Generally not recommended. The compositions differ significantly (34% overlap). These materials have different alloying concepts and are intended for different applications.
What is the difference between EN AW-6060 and EN AW-1050A?
The main differences are in the following elements: Si, Mg. EN AW-6060 is a Aluminum grade, while EN AW-1050A is a Aluminum grade.
Related Comparisons
View full data for each material:
Data provided for reference only. Always verify against the applicable specification for critical applications.
All data is for reference only. Equivalents indicate similarity, not identity. Always verify against the applicable specification for safety-critical applications. materialref.com accepts no liability for decisions based on this data.