9SMnPb28 vs P355GH: 33% composition overlap. Significantly different materials serving different application areas.
9SMnPb28 vs P355GH
Side-by-side chemical composition and mechanical property comparison.
Overview
9SMnPb28
1.0718
Leaded free-cutting steel — Pb (0.15-0.35%) + S (0.24-0.33%) for maximum machinability. THE ultimate Automatenstahl: machinability rating ~175% (vs 100% for 11SMn30). Pb acts as chip-breaker and tool lubricant. Used for high-speed automatic screw machine production of screws, nuts, fittings, bushings, and any part where surface finish and cycle time matter most. NOTE: Pb content being phased out under EU ELV/RoHS — replacement grades emerging.
P355GH
1.0473
Higher-strength pressure vessel steel — ReH >=355 MPa, guaranteed elevated-temperature properties. Between P265GH and 16Mo3 in the pressure vessel hierarchy. Used for boilers, steam drums, heat exchangers, and pressure piping operating to ~400°C. EN 10028-2, PED 2014/68/EU compliant. Good weldability.
| 9SMnPb28 | P355GH | |
|---|---|---|
| Material Number | 1.0718 | 1.0473 |
| Category | Carbon Steel | Carbon Steel |
| Standard | EN 10087 | EN 10028-2 |
Chemical composition (wt%)
| Element | 9SMnPb28 | P355GH | Overlap |
|---|---|---|---|
| C | 0–0.14% | 0–0.22% | OK |
| Si | — | 0–0.4% | — |
| Mn | 0.9–1.3% | 0–1.6% | OK |
| P | 0–0.06% | 0–0.025% | OK |
Mechanical properties
| Property | 9SMnPb28 | P355GH | Unit |
|---|---|---|---|
| tensile_strength | 370–500 | 490–630 | MPa |
| yield_strength | 230–300 | ≥ 355 | MPa |
| elongation | 14–22 | ≥ 20 | % |
Compatibility Assessment
9SMnPb28 and P355GH have significantly different compositions (33% overlap). These materials are not interchangeable and serve different application areas.
Automated assessment based on composition analysis
Frequently Asked Questions
Is 9SMnPb28 the same as P355GH?
9SMnPb28 and P355GH have a 33% composition overlap. They are generally not directly interchangeable.
Can I replace 9SMnPb28 with P355GH?
Generally not recommended. The compositions differ significantly (33% overlap). These materials have different alloying concepts and are intended for different applications.
What is the difference between 9SMnPb28 and P355GH?
The main differences are in the following elements: S. 9SMnPb28 is a Carbon Steel grade, while P355GH is a Carbon Steel grade.
View full data for each material:
Data provided for reference only. Always verify against the applicable specification for critical applications.
All data is for reference only. Equivalents indicate similarity, not identity. Always verify against the applicable specification for safety-critical applications. materialref.com accepts no liability for decisions based on this data.