9SMnPb28 vs S690Q: 32% composition overlap. Significantly different materials serving different application areas.
9SMnPb28 vs S690Q
Side-by-side chemical composition and mechanical property comparison.
Overview
9SMnPb28
1.0718
Leaded free-cutting steel — Pb (0.15-0.35%) + S (0.24-0.33%) for maximum machinability. THE ultimate Automatenstahl: machinability rating ~175% (vs 100% for 11SMn30). Pb acts as chip-breaker and tool lubricant. Used for high-speed automatic screw machine production of screws, nuts, fittings, bushings, and any part where surface finish and cycle time matter most. NOTE: Pb content being phased out under EU ELV/RoHS — replacement grades emerging.
S690Q
1.8928
High-strength quenched and tempered structural steel — YS 690 MPa min. Part of EN 10025-6 series (S500Q to S960Q). Good weldability despite high strength (CEV controlled). Used for mobile cranes, mining equipment, truck chassis, bridge components, and any structure where weight reduction through higher strength is critical. "Q" = quenched, "L" variants add low-temp impact.
| 9SMnPb28 | S690Q | |
|---|---|---|
| Material Number | 1.0718 | 1.8928 |
| Category | Carbon Steel | Carbon Steel |
| Standard | EN 10087 | EN 10025-6 |
Chemical composition (wt%)
| Element | 9SMnPb28 | S690Q | Overlap |
|---|---|---|---|
| C | 0–0.14% | 0–0.2% | OK |
| Si | — | 0–0.8% | — |
| Mn | 0.9–1.3% | 0–1.7% | OK |
| P | 0–0.06% | 0–0.02% | OK |
Mechanical properties
| Property | 9SMnPb28 | S690Q | Unit |
|---|---|---|---|
| tensile_strength | 370–500 | 770–940 | MPa |
| yield_strength | 230–300 | ≥ 690 | MPa |
| elongation | 14–22 | ≥ 14 | % |
Compatibility Assessment
9SMnPb28 and S690Q have significantly different compositions (32% overlap). These materials are not interchangeable and serve different application areas.
Automated assessment based on composition analysis
Frequently Asked Questions
Is 9SMnPb28 the same as S690Q?
9SMnPb28 and S690Q have a 32% composition overlap. They are generally not directly interchangeable.
Can I replace 9SMnPb28 with S690Q?
Generally not recommended. The compositions differ significantly (32% overlap). These materials have different alloying concepts and are intended for different applications.
What is the difference between 9SMnPb28 and S690Q?
The main differences are in the following elements: S. 9SMnPb28 is a Carbon Steel grade, while S690Q is a Carbon Steel grade.
View full data for each material:
Data provided for reference only. Always verify against the applicable specification for critical applications.
All data is for reference only. Equivalents indicate similarity, not identity. Always verify against the applicable specification for safety-critical applications. materialref.com accepts no liability for decisions based on this data.