C15E vs S355JR: 45% composition overlap. Significantly different materials serving different application areas.
C15E vs S355JR
Side-by-side chemical composition and mechanical property comparison.
Overview
C15E
1.1141
Low-carbon unalloyed case hardening steel — 0.12-0.18% C. Between C10E (softer core) and C22E (harder core) in the case-hardening range. Good balance of surface hardness (HRC 58-62) and core toughness after carburizing. Modern designation for Ck15. Used for small gears, pins, bushings, levers, and carburized parts where moderate core strength is acceptable. Also used for cold forming and deep drawing.
S355JR
1.0045
High-strength low-alloy structural steel with minimum yield strength of 355 MPa. Standard grade for bridges, buildings, cranes, and general structural applications. Impact tested at +20°C (JR).
| C15E | S355JR | |
|---|---|---|
| Material Number | 1.1141 | 1.0045 |
| Category | Carbon Steel | Carbon Steel |
| Standard | EN 10084 | EN 10025-2 |
Chemical composition (wt%)
| Element | C15E | S355JR | Overlap |
|---|---|---|---|
| C | 0.12–0.18% | 0–0.24% | OK |
| Si | 0–0.4% | 0–0.55% | OK |
| Mn | 0.3–0.6% | 0–1.6% | OK |
| P | 0–0.025% | 0–0.035% | OK |
Mechanical properties
| Property | C15E | S355JR | Unit |
|---|---|---|---|
| tensile_strength | 350–490 | 470–630 | MPa |
| yield_strength | 210–260 | ≥ 355 | MPa |
| elongation | 25–32 | ≥ 22 | % |
Compatibility Assessment
C15E and S355JR have significantly different compositions (45% overlap). These materials are not interchangeable and serve different application areas.
Automated assessment based on composition analysis
Frequently Asked Questions
Is C15E the same as S355JR?
C15E and S355JR have a 45% composition overlap. They are generally not directly interchangeable.
Can I replace C15E with S355JR?
Generally not recommended. The compositions differ significantly (45% overlap). These materials have different alloying concepts and are intended for different applications.
What is the difference between C15E and S355JR?
The main differences are in the following elements: overall alloying content. C15E is a Carbon Steel grade, while S355JR is a Carbon Steel grade.
Related Comparisons
View full data for each material:
Data provided for reference only. Always verify against the applicable specification for critical applications.
All data is for reference only. Equivalents indicate similarity, not identity. Always verify against the applicable specification for safety-critical applications. materialref.com accepts no liability for decisions based on this data.