PEEK GF30
PEEK with 30% short glass fiber reinforcement. Dramatically increased stiffness (E-Mod 11 GPa vs 4.1 unfilled) and strength (UTS 160 vs 100 MPa) with reduced elongation and creep. Maintains PEEK's chemical resistance and high-temp capability (continuous 250°C). Trade names: Victrex 450GL30, TECAPEEK GF30 (Ensinger), KetaSpire GF30 (Solvay). Used for structural brackets, pump housings, valve seats, bearing cages, and semiconductor wafer handling where higher stiffness than unfilled PEEK is needed.
Mechanical properties — Pro
Standard
| Property | Value | Unit |
|---|---|---|
| Tensile Strength | ||
| Elongation | ||
| Elastic Modulus | ||
| Density | ||
| hdt_1.8mpa |
Sign up free and get 5 full lookups immediately.
Sign up free — 5 lookups/day freeRelated materials
EPDM (Ethylene Propylene Diene Rubber)
Ethylene propylene diene monomer rubber — THE outdoor/weather elastomer. Saturated backbone gives outstanding ozone, UV, and weathering resistance. Excellent resistance to steam, hot water, and polar solvents. NOT resistant to oils/fuels (opposite of NBR). Good electrical insulation. ρ 0.85-1.3 (lightest common rubber). Used for automotive door/window seals, roofing membranes, radiator hoses, HVAC gaskets, and pond liners.
Epoxy/Carbon Fiber (CFRP)
Carbon fiber reinforced epoxy — the benchmark structural composite material. Unidirectional ply: tensile strength 1500–2000 MPa, modulus 120–150 GPa at density 1.55 g/cm³ (5x stronger than steel at 1/5 the weight). Quasi-isotropic layup: UTS ~600 MPa, E ~50 GPa. Autoclave-cured prepreg (aerospace) or infusion/RTM (industrial). Used in aerospace primary structures (fuselage, wings), Formula 1 chassis, bicycle frames, wind turbine blades, pressure vessels (Type IV) and high-end sporting goods. Fiber types: T300, T700, T800, M40J, M55J.
FKM (Fluoroelastomer / Viton)
Fluoroelastomer — THE high-temperature and chemical-resistant rubber. Outstanding resistance to oils, fuels, acids, and solvents at temperatures up to 200°C (short-term 230°C). Fluorine content (64-70%) determines chemical resistance. Trade names: Viton (Chemours), Tecnoflon (Solvay), Dai-El (Daikin). 5-10x more expensive than NBR. Used for aerospace fuel seals, chemical process seals, automotive fuel injector O-rings, semiconductor processing, and any seal exposed to aggressive chemicals at high temperature.
Not sure which material fits?
🤖 Ask AI Advisor →All data is for reference only. Equivalents indicate similarity, not identity. Always verify against the applicable specification for safety-critical applications. materialref.com accepts no liability for decisions based on this data.