EN AW-5083 vs EN AW-6101: 49% composition overlap. Significantly different materials serving different application areas.
EN AW-5083 vs EN AW-6101
Side-by-side chemical composition and mechanical property comparison.
Overview
EN AW-5083
3.3547
The highest-strength non-heat-treatable aluminium alloy. Excellent corrosion resistance (especially seawater), good weldability. Standard alloy for shipbuilding, offshore, pressure vessels, cryogenic applications, and armour plate. Not for continuous service above 65°C under stress (SCC risk).
EN AW-6101
EN AW-6101
Al-Mg-Si electrical conductor alloy — optimized for maximum electrical conductivity (56-57% IACS T6) while maintaining moderate strength. THE aluminum busbar and power cable alloy. Used for high-voltage busbars, electrical conductors, overhead transmission lines, transformer windings, and switchgear. Replaces copper at 1/3 the weight and lower cost per amp-meter.
| EN AW-5083 | EN AW-6101 | |
|---|---|---|
| Material Number | 3.3547 | EN AW-6101 |
| Category | Aluminum | Aluminum |
| Standard | EN 573-3 | EN 573-3 |
Chemical composition (wt%)
| Element | EN AW-5083 | EN AW-6101 | Overlap |
|---|---|---|---|
| Si | 0–0.4% | 0.3–0.7% | Partial |
| Mn | 0.4–1% | — | — |
| Cr | 0.05–0.25% | — | — |
| Cu | 0–0.1% | 0–0.1% | OK |
Mechanical properties
| Property | EN AW-5083 | EN AW-6101 | Unit |
|---|---|---|---|
| tensile_strength | 275–350 | 200–240 | MPa |
| yield_strength | ≥ 125 | 170–200 | MPa |
| elongation | ≥ 12 | 10–15 | % |
Compatibility Assessment
EN AW-5083 and EN AW-6101 have significantly different compositions (49% overlap). These materials are not interchangeable and serve different application areas.
Automated assessment based on composition analysis
Frequently Asked Questions
Is EN AW-5083 the same as EN AW-6101?
EN AW-5083 and EN AW-6101 have a 49% composition overlap. They are generally not directly interchangeable.
Can I replace EN AW-5083 with EN AW-6101?
Generally not recommended. The compositions differ significantly (49% overlap). These materials have different alloying concepts and are intended for different applications.
What is the difference between EN AW-5083 and EN AW-6101?
The main differences are in the following elements: Si, Mg. EN AW-5083 is a Aluminum grade, while EN AW-6101 is a Aluminum grade.
Related Comparisons
View full data for each material:
Data provided for reference only. Always verify against the applicable specification for critical applications.
All data is for reference only. Equivalents indicate similarity, not identity. Always verify against the applicable specification for safety-critical applications. materialref.com accepts no liability for decisions based on this data.